Read also the dsnet*.pdf and the setup*.pdf. The prompt will change from "dsedb S>" to "dsedb R>" and the DTL-T10000 will be started up by loading the application from disk. Start dsedb and execute the following commands. Insert the startup disk in the DTL-T10000. The procedure for starting an application from a startup disk on the DTL-T10000 is as follows.ฤก. Except where specifically stated otherwise, the term "DTL-T10000" below also includes the DTL-T10000H. If replacement is not performed in either 8MB or 2MB mode, the IOP memory size remains at 8 MB. Memory size after IOP module replacement is 2 MB. Memory size after IOP module replacement is 8 MB. DTL-T10000 flash need not match library version on disk. IOP debugger supported at level of release 1.3.4 functionality (1/19/00 release). DTL-T10000 flash must match library version on disk. Most current IOP debugging environment. After replacement, the memory size can also be set. The flash memory can be replaced during disk startup. An application can be started from a normal startup disk on the DTL-T10000 or DTL-T10000H using the dsedb boot parameter, in a manner similar to the DTL-H10000.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |